Note: 1. 2. Press and hold the measurement trigger and the laser will activate for aiming guidance. 1. Report any errors on this page in the comment box below. Max Temperature / Emissivity Result 8. As the distance between the thermometer and the surface increases, the total surface area measured will also increase. Should you have any questions or concerns, feel free to contact our helpful customer support team toll-free at 855.686.3835 or by email at firstname.lastname@example.org. • DO NOT use leaking batteries or dispose old batteries in fire. 2. Besides, the steam, dust, smog will lower the accuracy of testing. Plaster 0.89-0.91 Emissivity The emissivity of a material is its efficiency in emitting thermal energy. DO NOT DISASSEMBLE THE DEVICE. Open the battery compartment and remove the used battery. With a temperature measurement range that surpasses boiling points, the possibilities are endless. A laser light aids in aiming, and can be turned on or off. This thermometer cannot test the temperature of target objects through across the glass. inimo WIN NOTE: The Lasergrip LCD will display 'OH' when the measured temperature is above the measurable range, and will display 'OL' when the measured temperature is below the measurable range. -1 - 2 - - 4 Battery Replacement Distance (D) to Spot (S) size D:S = 12:1 ETEKCITY LASERORP10722 The device certification information is labeled directly on the device. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received. NOTE 1. Adjustable Emissivity Sign SCAN HOLDA N NON OF 000.0°C -MAX 8988 CAUTION Unit Conversion To switch between units of temperature measurement, press the °C/°F button at any time while the Lasergrip is on. Battery Compartment Emissivity Adjustment Mode To adjust the emissivity value before measurement, press the emissivity adjustment mode button, then use the UPA and DOWN V buttons to navigate to the desired value. Post was not sent - check your email addresses! This creates a spot measurement area of 1.18 inches (3 cm) in diameter. 5. Press the measurement trigger once again to make another measurement. transparent 0.95 Brass Polished 0.02-0.05 Rubber 0.95 The device warning and aperture safety information are also labeled directly on the device; the sticker is located on the right side of the Lasergrip. Reliable Product This is a big seller in Amazon and many respected institution like Car Magazines, Airports, Universities purchase this product from us! Aluminium 0:00 in) =(1-18 in $ 11.81 in 14.17 in recommended 0.98 Oxidized 0,20-0, 60 non Oxidized 0.5 Plastic A low battery icon will appear on the LCD display when the Lasergrip's battery power is running low. Make sure to insert the battery in accordance with the correct polarities indicated. You deserve it! Once the battery is properly installed, press the measurement trigger to activate the device. 1x Etekcity Lasergrip 1022 Thermometer 1x 9V DC Battery 1x User's Manual Note: 1. This Etekcity non-contact IR temperature gun is easy to operate. Laser On Back-light On Continue Scanning 5. Laser Hole 7. • DO NOT disassemble the device or tamper with internal 2000 6 Function Diagram 1. Laser radiation may cause damage to eyes. You may refer to the emissivity reference chart for correct surface emissivity values. For best accuracy, the distance between the thermometer and object of measurement shold approximately be 14.17inches (36cm). The recommended distance to hold the Lasergrip from the surface of measurement is 14.17in (36 cm).